Besa-lighting Willow (Mini Pendants 12V) User Manual download pdf

QUICK CONNECT INSTALLATION GUIDE

Model XP Willow LED Series (Low Voltage LED Pendant Set 12V)

XP_Willow_LED, Rev.1 5-13

6695 Taylor Rd. Blacklick, OH 43004

www.besalighting.com

This low voltage Pendant Cord Assembly has been designed to be used with Besa Low Voltage Quick

Connect Adapters. Operate with a low voltage transformer (12V) and never wire directly to 120 volts.

1. Making a clean cut, shorten the cord to the desired length.

6. Feed the wire until it reaches the top set screw position. Confirm

by viewing the Center Conductor through the Viewing Hole.

7. The Brass Collar should align with the bottom of the

Quick Connect Jack, if not then trim the Center Conductor.

8. Tighten the top set screw first, then the lower. Do not overtighten

the set screws and make sure the set screws avoid the seam

in the Brass Collar. The pendant can now be installed onto

Quick Connect Adapter.

9. Insert the post of the Quick Connect Jack into the

Quick Connect Adapter. Thread the top half of the

conical section until it seats with the adapter.

4. Remove the exposed braiding by pulling away from

the center conductor, then cutting off excess.

Leave 1/16” of braided material or less.

2. Carefully strip off 1-3/4” of the outer jacket using

the Stripping Tool provided.

It is important not to damage the

inner silver braiding. Practice this

step on a scrap section of cord first.

1-3/4”

3. Slide the Brass Collar over the braiding.

Make sure the Brass Collar does not

damage the braiding to ensure

a good connection.

1/8”

5. Strip off 1/8” of insulation from the Center Conductor.

The exposed stranded wire of the Center Conductor

must be tightly wound before proceeding.

Gently Tighten

Using Pliers

Loosen Set Screws,

If Necessary

Orient So Set Screw

Is Not On Seam

IMPORTANT: KEEP THESE INSTRUCTIONS FOR YOUR RECORDS

All electrical connections and the installation of this fixture must be in agreement with local codes,

ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).

Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.

All electrical connections and the installation of this fixture must be in agreement with local codes,

ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).

Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.

1 2 3

Summary of Contents

Page 1

QUICK CONNECT INSTALLATION GUIDEModel XP Willow LED Series (Low Voltage LED Pendant Set 12V)XP_Willow_LED, Rev.1 5-136695 Taylor Rd. Blacklick, OH 4

Page 2 - Lightsource

All electrical connections and the installation of this fixture must be in agreement with local codes, ordinances or the NEC (National Electric Code)

Page 3 - FIXTURE INSTALLATION GUIDE

6695 Taylor Rd. Blacklick, OH 43004www.besalighting.comFIXTURE INSTALLATION GUIDEModel Willow LED (1 Light Low Voltage LED Dome Canopy)1XT-1XC_Willow

Comments to this Manuals

No comments

Besa-lighting Willow (Mini Pendants 12V) User Manual

Browse online or download User Manual for Lighting Besa-lighting Willow (Mini Pendants 12V). Besa Lighting Willow (Mini Pendants 12V) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Besa-lighting Willow (Mini Pendants 12V)